The Ethernet-DMX4 MkII is an Ethernet node that serves 4 DMX512 outlets, compatible with the Artnet protocol. All outlets are conform to DMX512-A and can be used as input or output. The two Ethernet links on the front and at the rear are 10/100BaseTX connections on Neutrik RJ45 Ethercon connectors. All configuration can be done over Ethernet through a build in Web site, by using the jog on the front end, or through LumiNet Monitor V.2 software. This all comes in a 19″ 1 unit high metal housing that can be rack mounted.
Key features
- DMX routing, universe setting
- Input and output enable / disable
- DMX input / output frame rate setting
- IP settings
- Unit ID and labeling
- Ethernet activity indication on front panel
- Up to 40 programmable profiles and routings
- Up to 10 predefined profiles (ethernet, splitters, mergers)
Connections
- 2 10/100BaseTX Ethernet connections on Neutrik RJ45 Ethercon connector
- 4 DMX512-A in/outputs on shielded and isolated 5 pin female XLR, with termination (DMX512-A)
Operation
- Ethernet <-> DMX (ArtNet)
- DMX Merger
- DMX Backup
- DMX splitter / booster
- DMX trigger. Remote selection of the merging policy through DMX
- Built-in DMX softpatch
- Wysiwyg enabled. DMX inputs can be visualised in Wysiwyg
- DMX snapshot. Capture 3 lighting states (fixed values) per outlet
- Modification of captured values from the Web interface
- Auto-load capture on boot-up (ideal for expo)