Ethernet-DMX4 MkII / RM

This product has been discontinued. Replaced by LumiNode 4

The Ethernet-DMX4 MkII is an Ethernet node that serves 4 DMX512 outlets, compatible with the Artnet protocol. All outlets are conform to DMX512-A and can be used as input or output. The two Ethernet links on the front and at the rear are 10/100BaseTX connections on Neutrik RJ45 Ethercon connectors. All configuration can be done over Ethernet through a build in Web site, by using the jog on the front end, or through LumiNet Monitor V.2 software. This all comes in a 19″ 1 unit high metal housing that can be rack mounted.

Key features

  • DMX routing, universe setting
  • Input and output enable / disable
  • DMX input / output frame rate setting
  • IP settings
  • Unit ID and labeling
  • Ethernet activity indication on front panel
  • Up to 40 programmable profiles and routings
  • Up to 10 predefined profiles (ethernet, splitters, mergers)


  • 2 10/100BaseTX Ethernet connections on Neutrik RJ45 Ethercon connector
  • 4 DMX512-A in/outputs on shielded and isolated 5 pin female XLR, with termination (DMX512-A)


  • Ethernet <-> DMX (ArtNet)
  • DMX Merger
  • DMX Backup
  • DMX splitter / booster
  • DMX trigger. Remote selection of the merging policy through DMX
  • Built-in DMX softpatch
  • Wysiwyg enabled. DMX inputs can be visualised in Wysiwyg
  • DMX snapshot. Capture 3 lighting states (fixed values) per outlet
  • Modification of captured values from the Web interface
  • Auto-load capture on boot-up (ideal for expo)
Input 1 x Neutrik RJ45 Ethercon connector (front)
1 x Neutrik RJ45 Ethercon connector (rear)
Outlets 4 x shielded Neutrik 5 pin XLR (female)
RJ45/EtherCon Ports: 10/100 BaseTX
RJ45/EtherCon (10 or 100Mbps) auto-negotiation
DMX Port direction: input/output (configurable)
DMX Port refresh 10-40 fps
DMX Port Termination/Biasing Yes
Port isolation Optic isolation per port
Galvanic isolation per two ports
DMX protocol DMX512 (1990), DMX512-A
Break 180 µs
Mark After Break (MAB) 30 µs
Ethernet Ports Connection Link and activity
Power LED indication
Monitoring software LumiNet monitor V.2 at no cost
Wysiwyg Enabled yes (visualize inputs)
Power input 90-260 VAC
47-63 Hz
Power consumption Maximum 20 W
Operating temperature 0 to +60 °C
Power Consumption Maximum 15 W
Fuse 1A 250V Slow Blow
Power over Ethernet (PoE) Support Optional
Operating temperature 0 to +60 °C
Storage temperature -10 to +70 °C
Size 482 x 153,5 x44 mm