Installation
1. Save the console show to diskette.
2. Turn the console power off.
3. Insert the diskette into the console disk drive.
4. Press and hold the "Record" button while turning power on.
5. Press the "Load FLASH" button in the programmer toolbar.
6. Press the "Yes" button in the programmer toolbar.
7. The console will restart and deep clear when finished.

Note: V4.2 shows cannot be loaded directly into a V5.0 console.

Release Notes
V5.0.1.4 (16/12/2003):
- Can now reassign a MIDI Programmer stack.
- Can now resume a Halted chase by pressing Go+Assign.
- Fixed bug apparent with concurrent cross-fading chases.
- Fixed bug where re-recording Palettes wasn't changing LTPs of fixtures that were recorded without intensity.

V5.0.1.3 (07/10/2003):
- Fixed Palette labeling on Page 3.
- Fixed pan disappearing from LCD.
- Fixed Intensity sometimes stays on when homing fixtures.
- Fixed Intensity sometimes stays at zero when playing back.

V5.0.1.2 (20/6/2003):
- Assign Master Flash buttons now have a setup option to allow them to operate either as instants or over time.
- Fixed a few issues with chases re erratic fading between steps.

V5.0.1.1 (No public release):
- Data on the programmer LCD wasn"t being updated sometimes.
- Added setup option for an alternate Encoder Wheel with greater sensitivity.

V5.0.1.0 (12/5/2003):
- Fixed show memory bug that was causing the console to consume more memory than necessary.V5.0.0.11 (17/4/2003):
- Fixed Scroller fade bug found during off-site testing of 5.0.0.10

V5.0.0.10 (No public release):
- Fixed fader patch. Note that fader memory and chase data for shows recorded with console versions prior to V5.0.0.10 may not load correctly due to this fix.
- Fixed a bug with adding wheel movements to a 16-bit parameter while an effect was running.
- Console now correctly calculates the available disk space. Was causing save show failures.
- Position Palettes with 16 bit Pan/Tilt are now correctly restored.
- Effects on fixtures patched to DMX2 were causing the intensity to change.
- Pan was being intermittently lost from the programmer LCD.
- Colour in Chases in Stack werent playing back properly.
- Problems with the Wide mode menu (number of faders) fixed.
- Memory fadeout was not working correctly. The wrong memory's Fade Out time was being used.

V5.0.0.9 (24/01/2003):
- Console now reloads preset assigns when palettes have changed in the same way normal assigns do.
- Preset assigns revert to presets when the assigned memory is deleted.
- Fixed up Assign Stack menu.
- Clearing palettes menu now shows the labels correctly.
- Pressing a palette button while labelling a palette now uses the selected page.